I searched everywhere for this.
It would seem from brief visual comparison that the exhaust mani, cat(s) and piping would swap over to a zx2. Im wanting to do this for a cost saving measure as there are a LOT of wrecked low mileage zx3, zx4, focus etc that I could pull exhaust components from. Is this possible with some mods (welding, cutting, bending..) ?
If there is a thread that already answers this question, then ok then.
It would seem from brief visual comparison that the exhaust mani, cat(s) and piping would swap over to a zx2. Im wanting to do this for a cost saving measure as there are a LOT of wrecked low mileage zx3, zx4, focus etc that I could pull exhaust components from. Is this possible with some mods (welding, cutting, bending..) ?
If there is a thread that already answers this question, then ok then.