Starting to design boxes.. | Ford Escort Owners Association (FEOA)
  1. Wash your hands and do not touch your face, keep it safe and clean. Long live Feoa!

Starting to design boxes..

Discussion in 'ICE (In Car Entertainment)' started by Green91Goblin, Jun 5, 2011.

  1. Green91Goblin

    Green91Goblin New Member

    Messages:
    1,389
    Likes Received:
    1
    Trophy Points:
    0
    Location:
    Corinth, MS
    I'm designing one for myself, and was wondering who else might be interested? Here is mine for Deathscort, designed for a Sundown Nighshade 12V1 Dual 2.

    Albeit they are a bit amateur, and I haven't had the time do determine Cu. ft. in the enclosure area, but here they are! From rough draft to current!

    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]

    Thoughts? Opinions?
  2. neuspeedescort

    neuspeedescort Moderator Staff Member

    Messages:
    8,125
    Likes Received:
    98
    Trophy Points:
    348
    Location:
    wenatchee, wa
    caps are a waste of money. seems you will have a second battery already its double a waste. other then that is not a bad design. i would get your stetch up to round up to 1/4 or 1/2 inch instead fo 32nds. its a headache to cut that accurate for a speaker box.


    NEUMAN
  3. Green91Goblin

    Green91Goblin New Member

    Messages:
    1,389
    Likes Received:
    1
    Trophy Points:
    0
    Location:
    Corinth, MS
    Yeah, big 3, the whole 9 yards. Only reason I wanted a cap was to measure voltage at the source, unless you know any cheaper methods. How much do the voltage display batt terminals cost?
  4. neuspeedescort

    neuspeedescort Moderator Staff Member

    Messages:
    8,125
    Likes Received:
    98
    Trophy Points:
    348
    Location:
    wenatchee, wa
    just buy a digital volt meter and throw it in the front of the cup holder. can be found for 35-70 bucks on line.


    NEUMAN

Share This Page