FEOA Forums banner
1 - 1 of 1 Posts

1,176 Posts
as to replace the boots of your axles, you need to :

1- lift the car
2- take out your tire/rim
3- unbolt either the tie-rod end and the balljoint or * more simple in my opinion* unbolt the 2 lower bolts that holds the macpherson strut in place where the strut meets the wheel spindle.
4- Unbolt the 30 mm axle nut * grease it up before you do*
5 - push on the axle towards the transmission to take all the loose off, and then work it out of the hole of the wheel spindle..
6 - you should then be able to take off the old boot and slide on the new one...
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.