FEOA Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
60 Posts
Discussion Starter · #1 ·
Is there a way to cut the shifter on the 98 scort shorter? I'd like to cut it down a couple of inches, but I can't think of what to use....any ideas/suggestions?
 

·
Registered
Joined
·
914 Posts
Eh. Just sawing off the end won't give you a short shifter, it'll give you a short-er shifter, but not a short shifter... Somewhere around here or on ERDT there's a how to about how to make one.
 

·
Premium Member
Joined
·
1,675 Posts
Take a torch and heat the ball up, bang it loose, then you can slide it up a bit (1-2" or so). Then drill it and put a pin/set screw to hold it where you want it. Woohoo free short shifter. You will probably have to bend the exhaust heat shield in the area where the shifter is.
 

·
Registered
Joined
·
8,915 Posts
coyote-x said:
Eh. Just sawing off the end won't give you a short shifter, it'll give you a short-er shifter, but not a short shifter... Somewhere around here or on ERDT there's a how to about how to make one.
exactly why I just said buy one.
 
1 - 6 of 6 Posts
Top