FEOA Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
863 Posts
Discussion Starter · #1 ·
OK i'm having issues trying to recalibrate my Rx7 VaF , i have a basic idea where is supposed to be an the car will run mint BUT ill either have no top end past 6k or feels stock .

ive searched my face off looking for any timbit of info about recalibrating these an come up short.

If any one has the proper voltage specs it would be greatly apreciated

~Adam
 

·
Registered
Joined
·
863 Posts
Discussion Starter · #3 ·
i found that but the motor wont rev past 6k even when set with in 0.45v and 0.78v , i already know how to tune the vaf but i was looking for more in depth info on it .

at the vaf signal wire the car runs normal set between 2.65 an 3.0 volts but does not make any power but revs normal.

trying to find the cars sweet spot again is a pain in the ass :mad:

i have a new problem with injector o-rings leaking now :wall: so ill worry about this when i sort that out :wall:
 
1 - 3 of 3 Posts
Top