FEOA Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
333 Posts
Discussion Starter · #1 ·
I just noticed some rust on both rear wheel wells and i am wondering what i should do. It is not all the way through so i was thinking mabye i could sand it off (though i am not sure exactly how to do that) and then use some touch up paint on it. I dont know what kind of paint to use and how to make it look the least obvious so any help or suggestions would be appreciated. Thanks.
 

· Registered
Joined
·
2,726 Posts
The rust IS coming from the INSIDE of those body panels and IS a lot worse than it looks right now because it is finally making its way through t the outside.

Unless you want a hugh amount of work...take it to a body shop for them to fix.....trust me on this...I´ve done my fenders (cut & paste) and I don´t want to ever do it again.

Also get you car rust proofed on the INSIDE of all your panels...by taking off your interior fabric panels for spraying in the oils.
 

· Registered
Joined
·
333 Posts
Discussion Starter · #3 ·
I pressed hard on the spots where the rust is and it didnt cave in like i thought it would if it was rusted through so that is why i thought it was surface rust and i could just sand it off but if it is comming from the inside and i have to take it to get fixed how much do you think this is going to cost me.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top