FEOA Forums banner


1503 Views 12 Replies 6 Participants Last post by  Juggernaut
i was wondering if anybody here knows how to cut through the metal of an exhaust manifold? what equipment would i need?
1 - 1 of 13 Posts
I believe the turbo on the 1st gen Eclipse is a T25 (I don´t know which make... Garrett? Turbonetics?), which should work fine with the escort motor if you can get the manifold for it to bolt to. I don´t know if a T25 will bolt up to the flange at corksport.

What condition is the turbo in? Be sure there´s no play and that it spins freely.. no use taking the time to install a POS turbo.. It´s going to spin at some incredibly high rpms and you don´t want it to start throwing little bits of compressor wheel into your intake if it´s defective.
1 - 1 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.