FEOA Forums banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
8,143 Posts
wire each sub at 4 ohms. one thing you guys are failing to notice is his amp is a mono amp. this will run your amp at 1ohm. increasing teh ohm load doesn't increase your power handling. so 500 is 500. but since you will be at 1 ohm on each in the end your maximum power handling across the board will be 1500. your amp is a 1000. but that fosgate probly births out at around 1200-1300. so your set!

don't run middle to out. you will not have enough speaker connection point. if you run the proper wire your subs will not be able to handle 3 wires twisted together in the push down connections.

if you give me your email i can send you a picture of te proper wiring diaghram.


NEUMAN
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top