FEOA Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
5,792 Posts
Discussion Starter · #1 ·
OK, the pressure line that goes from the top of the pump to the rack is leaking really good where it screws into the pump. Is there suppose to be an o ring or something in there? It's a compression fitting so it should seal when tightened.
 

·
Registered
Joined
·
495 Posts
I had the same problem, it appears to be a compression fitting while in the book it shows a banjo bolt, I just threw some teflon on and it was good.
 

·
Registered
Joined
·
5,792 Posts
Discussion Starter · #3 ·
I guess I could try some Teflon even though you really not suppose to use it with compression fittings.
 
1 - 5 of 5 Posts
Top