FEOA Forums banner
1 - 10 of 10 Posts

· Registered
Joined
·
111 Posts
Discussion Starter · #1 ·
Hey can anyone help me with the removal of the stock gauge faces cause I just made some off of a site, but I don´t know how to take the needles off and faces without messin anything up. I also got the site for white gauges for 2nd gen and I´ll post it if I get a reply on how to do this.
 

· Registered
Joined
·
111 Posts
Discussion Starter · #2 ·
Also If anyone knows what the bulb number is behind the dash cluster so I can change the bulb color. Or what kind of bulbs they are,would be helpful.

_________________
94 Scort Sportin´ Nothin´.....Or am I??

[ Edited by SuperScort On Date 07-16-2002 ]
 

· Registered
Joined
·
838 Posts
the bulb # should be 194. most cars are. I´m not sure about the taking off the needles part, I tried it once on my Stang, and ended up breaking the damn thing. You said there was a site to go to to make whit guages? Where is it, and how does it work?
 

· Registered
Joined
·
111 Posts
Discussion Starter · #4 ·
Hers a pic of the guages installed. Scroll to the middle.

And here is the site to download them.

www.chez.com/savoienb/

Go to the bottom of the page and click on Gauge MPH only. And print them on photo quality paper at 600 dpi.

_________________
94 Scort Sportin´ Nothin´.....Or am I??

[ Edited by SuperScort On Date 07-17-2002 ]
 

· Registered
Joined
·
128 Posts
i put white gauges on my 94 gt, the needles are a bitch to get off, just pull on them and they will come off, the speedometer needle has a little black piece on it it comes off sometimes when you pull on the needle but it pops back on no problem. i used a pliers gently on the needle for the ones that were stuck. before you pull them off right down were your car idles for the rpm gauge so when you put it back on you can adjust it to were it needs to be by pulling it off and putting it back on were it reads correctly. same goes for the speedo needle, take your car out and find what rpm your car runs at a certain speed so you can check to make sure that it is correct when you put it back on. also the same goes with the water and fuel gauges. i didn´t have my fuel gauge needle in the correct position and almost ran out of gas. just remember where they were when you took them off. hope this helps
 

· Registered
Joined
·
128 Posts
and yes they are 194´s, you can get almost any color bulb you want, there are 5 in the gt. the only thing is is that the odometer has green tint to it and i could not remove it so i made mine green to match, turns out the stereo i have lights up green to so it worked out good, and the heater controlls as well
 

· Registered
Joined
·
40 Posts
Tried to download the guages but the server had an internal error and wouldn´t let me.
 

· Registered
Joined
·
8,351 Posts
You don´t necessarily have to make the gauge faces, you can go to NOPIonline.com and buy them in a variety of colors, i wanna make mine white gauge face with Red lettering, they´ll cost ya a pretty penny. (79.37 to 125.55, for one of 10 choices) But i don´t want to have to go through all the work to make them and then they come out wrong, (with my luck i KNOW that´ll happen) so i´ll just go with buying them, eventually.

Red 92 EGT
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top