Discussion in 'Photo Forum' started by r1234, Jun 5, 2017.
with dash back in
AHA! OK...knowing what you did makes it much clearer what you are doing.
Where did you have to trim the mustang chassis when you shortened it and narrowed it?
i took the lenght out in the frame rails at rear seat hump, as for the width just trimmed till it fit,if you look at rear of car you will see the rails that have to be trimmed off is what i removed off tail clip, front clip lost just the arch of rad supprt
more shots of what i did
I see what you did. Is the stock hood going to fit?
I have a similar project in the works. I took a '66 Chevy Nova and cut out the firewall, floor and trunk and replaced it with a tube chassis and all C6 corvette aluminum lower arms, Custom upper arms, C6 transaxle and turbocharged LS3 with LS7 heads.
i'm not hating but man if you would have done a sedan.......
looks nice i like the stance, here is the hood closed, it all ft like it should
i sill got a long way to go have fish plate every splice and roll cage it and find a motor and trans, never done always pushing forward,lol
Keep the post coming I want to see this thing run and drive.
He's not posted since june, I dono
r1234 was last seen:
Jun 30, 2017
Separate names with a comma.