FEOA Forums banner
1 - 17 of 17 Posts

·
Registered
Joined
·
295 Posts
Discussion Starter · #1 ·
Well, I sold my escort back in October, to a friend of mine. While cruising through the junk yard yesterday looking for seats for my Saturn, what do I come upon? a 1993 Mazda MX-3. The rear seat had been removed, but the front seats were in place. The Seats were a little dirty, but I couldn't resist...

I sure do Hope I can make em' fit!
 

·
Registered
Joined
·
295 Posts
Discussion Starter · #4 ·
Nopey, They are a no go, they come up to the sides of the seats. If I go to the junk yard, have any ideas as to what vehicles I ought look into?
 

·
Registered
Joined
·
295 Posts
Discussion Starter · #7 ·
Aah, but you see, it is not an escort, but a Saturn SL1. I am just putting them in cause the seats it had suck, but I can't manage to get rails that work. I guess I'll fabricate something... I'd like to get a an EGT or Mazda Protege, preferrably the Protege, I think... if anyone around Hampton Roads [VA] has seen any...
 

·
Registered
Joined
·
295 Posts
Discussion Starter · #8 ·


A little bit of steel, and a few cokes later... I'll do the other side tomorrow.

[cardomain is lagging]
 

·
Registered
Joined
·
295 Posts
Discussion Starter · #10 ·
It ought to be fine. it's 13 gauge steel, it was tough to drill through. The front is bolted in as it ought to be, the little brackets I made don't bend when I press foward on the seat very hard, I have a passenger side airbag, and the seatbelt receiver is going to be attached to the floor as opposed to the seat itself. I am pretty sure it will be fine...
 

·
Registered
Joined
·
295 Posts
Discussion Starter · #14 ·
I don't think I'm gonna keep them in there. I like them a lot, but if I find a saturn SC1/2 I am gonna snag the seats from that, cause I can't sell th car with these seats.
 

·
Registered
Joined
·
114 Posts
if u get ride of them let me know eventhough i don't know if they would fit in the egt since u made changes to the rails
 

·
Registered
Joined
·
1 Posts
anyone tried this in a zx2? and does anyone here know if the brackets are the same by anychance. Thanks for any help, and by the way i'm new here my name is john, I ussually post over at zx2ms but thought i'd see new things.
 
1 - 17 of 17 Posts
Top