FEOA Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
385 Posts
Discussion Starter · #1 ·
I have been reading about the KL-ZE/KL-03 mazda v-6 2.5L swap and I want to know what you guys think about the swap? I was first thinking about swaping a 1.8 EGT engine into my wagon but everything that is needed of that swap is needed for the mazda v-6 swaps. Well just wondering what you think, and I don´t want to swap the 2.0L SPI ( I´ve looked into that one)

Thanks

Justin GT :-Y
 

·
Registered
Joined
·
385 Posts
Discussion Starter · #6 ·
The KLZE is a j-spec. engine out of Japanese 626 / MX-6 and the KL03 is out of the 93+ Probe GT / 93-97 626 / 93+MX-6. I am going to buy a KL03 and order a set of heads/intake manifold/ and intake.

Justin GT :-Y
 

·
Registered
Joined
·
385 Posts
Discussion Starter · #8 ·
The transmission that most people yse is the trany off of a 1.8L V-6 MX-3, you also have to use the hubs, axles, and cross member of the same car.

I am not 100% sure that trany off the mx-3 will fit, I have to wait to talk to a guy that has done this swap, I will get back to you with the into.

Justin GT :-Y
 

·
Registered
Joined
·
385 Posts
Discussion Starter · #9 ·
A guy did this swap into a Mazda 323 ( 90 - 94 ) witch is also good for the escort if you didn´t already know that.

Stuff you get ( all MX-6 / MX-3 items )

Engine itself
Transmission
Drive Shaft
Computer & Harness
Engine Mounts
Sub Frame

check the site out
http://members.rogers.com/a_spec/services.html

Justin GT :-Y
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top