[SuperScort]

Alright I wanna do a custom cold air intake but I don´t feel like buying that intake adapter so I was wonderin can´t it be possible to make your own? Like go to a hardware store and buy a circle piece and a square piece and weld them. Also does anyone know the dimensions of the square piece that should go on?Thanks

 

[Pimp_scort_89_GT]

Thats what I´m talking about, some good old fashion "Why P-A-Y when I can D.I.Y." attitude. Go find some 3 inch tubing, and 1/8 in steel and weld up your own. As far as demintions go, if you are going to do it yourself, you better get used to using a tape measure. Take that bad boy and hold it next to the VAM and measure the disatnce between the holes, mark it out on the steel, center up the pipe, trace the diameter, cut and drillthe steel, weld up the tube and slap it on.

 

[SuperScort]

Right on thanks for the info Pimp_Scort