FEOA Forums banner
1 - 4 of 4 Posts

·
Premium Member
Joined
·
892 Posts
Discussion Starter · #1 ·
i pulled the head off the block of a good engine, had 90k on it and its been sitting for a while. it ended up getting rust on the upper half of the cylinder walls, so im wondering if i could use something to remove this or what i should do about it. iv got a good head for it so i dont wanna throw it away. any ideas?
 

·
Registered
1998 ZX2
Joined
·
10,065 Posts
How much rust are we talking about? The best thing would probably be to hone all the cylinders and replace the rings.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top