FEOA Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
13 Posts
The EDIS module itself controls the timing that is sent to the computer. If it cant send a signal to the computer then the computer cant send the timing needed back to the EDIS module to adjust the timing. When you are in "Limp Home Mode" you are at 10 degrees perminent fix not adjustable because the SAW coming out from the ecu to the EDIS is disconnected and therefore the edis wont have the timing adjustments from the ecu. Good thought on it but it isnt really going to work as easy as you think it is.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top