FEOA Forums banner
Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
493 Posts
Discussion Starter · #1 ·
Well after building this car for 2.5 yrs and since this season is over it's time for a different car.... So I am selling my Mazda Mx3 show car.
This car is one of a kind and was built from the ground up and still baffles people as to what it is!
You can get this car now and drive it for another 2 months or do some custom touches to it and have it ready for the 2010 show season!
This car runs and drives like new NO PROBLEMS what so ever!
NO test pilots but I will take you out for a ride if your serious about buying.
This is one of the cleanest MX-3's around with absolutly NO RUST under or on this car!!
Spent well over 15K into the car, I know I will never get that back thats why it's up for $5000
Basics:
SE model (#243 of 2000 hence the rare colour)
5 speed
1.8L V6
4 wheel disc brakes
FWD
NEVER Raced or beat on, has been babied with no winters.
Kmhs: 250,000

EXTERIOR
-MX-3 Eyelids
-MX-3 Projector headlights
-Custom 1 off Carbon Fiber wrapped shaved hatch.
-Custom Drift front bumper
-Molded Drift side skirts
-Buddy club 2 rear bumper
-Carbon fiber Invader style Hood
-Carbon Fiber Gas door cover
-Shaved antenna
-Shaved corner light
-Shaved rear bumper lights
-Shaved rear wiper
-Shaver rear and front wiper nozzles
-Custom Lambo Doors
-Blacked out tail lights
-Refinished wheel wells to original

INTERIOR
-Sparco Sprint Black seats
-G-Force 6 point racing harnesses 3 inch straps camlock
-Colour Matched and black Painted interior
-Custom door panels to hold 5 inchscreen and 5.5 inch mid speaker
-A pillar pod to hold 2 Prosport gauges Air/fuel and Vaccum/Boost
-Momo steering wheel
-Carbon Fiber pedals by Grounded Conceptz
-Custom Fiberglass trunk enclosure.
-Custom harness/B pillar bar
-1994 Complete Dash swap
-Colour Matched rear seats
-Fiberglassed Rear panels to hold mids

ENGINE BAY/SUSPENSION
-Custom Integra Cold air intake
-Powder coated Intake Manifold and Valve covers
-Every nut and bolt replaced with Stainless steel
-Custom MX3 Aluminum battery Tie down
-B&G Lowering springs
-KYB GR2 struts
-Brembo Cross drilled rotors

SOUND
-300 Watt Infinty MONO amp
-ROCKFORD P2 10 inch SUB
-2 Rockford 5.5 Mid speakers in each door panel
-2 Rockford 6" Mid speakers in rear panels
-2 Clarion 5 inch Screens

This are the current mods done to the car.
Current awards are:

2007 Importfest Baddest MX3/323 2nd Place
2008 Drift Mania Mazda WILD 1st place
2008 Importfest Baddest Mazda other 3rd Place
Lowered Intention car show 1st place Mazda
2009 Voicecoil Meltdown Mazda 1st place
2009 Drift Mania Mazda ELITE 2nd place
2009 Importfest Baddast MX3/MX6/Mazda3/Mazda6 2nd place

The SPARCO seats and HARNESSES Will NOT come with the car I will install originals.
CONTACT ME AT [email protected] OR 905-626-7968
Located WHITBY ONTARIO
Let your friends know if they are looking!









Absolutly NO RUST on and of the compnents (except the rotors which happen)

Old pic but you can see the door panels.
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top