FEOA Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
124 Posts
Discussion Starter · #1 ·
I need the positions for the timing of the cam and crank gears for a 98' dohc zx2? does any one have this information? maybe pictures?
 

·
Registered
Joined
·
261 Posts
get a piece of 1/4 inch wide and 1/8 inch thick steel rod and line up the holes on the cams and slide it through and they will be at tdc.(top dead center) then just line up the crankshaft with the alignment mark.
 

·
Registered
Joined
·
124 Posts
Discussion Starter · #6 ·
You all have been a great help for the backyard mechanic who can't afford the shop prices. My hats off to all who helped and to the forum for being here to help people like me...THANKS A MILLION
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top