FEOA Forums banner
1 - 10 of 10 Posts

· Registered
Joined
·
507 Posts
Discussion Starter · #1 ·
Fuses are good
all door light switches good.

What could be causing it? it doesnt work on both sides.

1. What is the module under the seat? Does that have anything to do with it?
 

· Registered
Joined
·
6,057 Posts
that module under the driver seat is the seatbelt control. most of the time this problem is usually due to a failing ignition switch so if ur brake light and fuel cutout light on the dash slowly fade in and out or r always on and there would be times where the engine won't crank, the ignition switch would be faulty(very common with these cars)
 

· Registered
Joined
·
507 Posts
Discussion Starter · #4 ·
Its not the ignition switch, Its never gave me any trouble.

The mechanisms work fine, as a matter of fact, one of them I just replaced a while ago.
 

· Registered
Joined
·
374 Posts
Key OFF.

Disconnect the passive restraint control module connectors.

Measure the voltage on the "Y" wires at passive restraint control module connector C1.

Key ON.

Measure the voltage on the "BK/Y" wire at passive restraint control module connector C2.

Are the voltages greater than 10 volts?

 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top