FEOA Forums banner
1 - 2 of 2 Posts

· Registered
444 Posts
Are you using it for fuel only or spark and fuel. If you are doing fuel only then it is rather simple to tie into the exsisting harness for you basic sensors(Clt,Iat,Tps,O2) Thats all it needs to run. Now if you are going the fuel and spark route, then I advise you to go and get a edis module out of the junk yard and start with that.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.