FEOA Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
if i put a set of struts front and rear (struts,mounts,bearing, boots, springs) together for a 2000 zx2 s/r will they bolt right in? just wanting to make sure before i do it and is zxtuner the only place to get Tokico SR struts and where can i get eibach ground controls? will this work for my car [http://cgi.ebay.com/SPC-Rear-Camber-Kit-Ford-Escort-Mercury-Tracer-91-94_W0QQitemZ370115923810QQcmdZViewItemQQptZMotors_Car_Truck_Parts_Accessories?hash=item562ca0cf62&_trksid=p3286.c0.m14&_trkparms=72%3A317%7C66%3A2%7C65%3A12%7C39%3A1%7C240%3A1318%7C301%3A1%7C293%3A17%7C294%3A50]

thanks in a advance
 

·
Registered
Joined
·
324 Posts
the only part that you would have to switch out is the ball joint but just use your zx2 spindels and you wont have to change the ball joint the zx2 ball joint is a little smaller around then the egt. but everything else is the same. i race a zx2 and a egt on dirt and had to do the same thing i took suspension componets from my parts car (egt1993) and put them on the zx2 2001.
 

·
Registered
Joined
·
4,694 Posts
You'll need the upper thrust bearings from a 97-up escort or zx2.
 
1 - 3 of 3 Posts
Top