curious if anyone has replaced that gas filler neck hose with a non standard replacement hose?
the hose goes on tight - what I would think...
Been considering doing the front struts for a while. (rears were changed out about 15 months ago)
My springs look fine.
Do not see rust....
I have the just about same chirp/squeak as the demonstrated in ChrisFix's video on YouTube.
The sound and circumstances for the sound is dead...
Managed to remove the ball joint on driver side.
Can't get the middle bolt to go into the hole past the bulge on the hub assembly. Burned at...
Looking for a picture of the AC rear hose or
liquid line refrigerant hose
from a 2nd gen.
I have a 3rd gen but there are currently conflicting...
Attempted to change north South mounts. Met failure.
During hasty re-assembly, could not get the inner bolt one the back mount to sink into...
I've been running with no timing cover for about 2 years or so now... however, have been debating to put the cover back on or not. It's...
Hi. Been a while since last posted.
Driving local. Turn into McDonald's. Had to make a U like turn due to way parking lot entry...
my preference is Blue.
but really, if anyone would share experience would be appreciated.
maybe one that failed early despite what should...
For sale, 3rd gen speedometer with tach for 2.0 SPI SOHC - not ZX2.
Good chance to get a nice speedometer with tach for diagnostics
Do you suffer from Low-T?
Have you ever felt the need to rip open the door just to get it to open?
Have you ever pulled really really hard then...
look what i found (big item):
and what else (not so big item but alarming nonetheless):
switched out the plug...
i just saw this and would like to share....
sometimes, i find it mildly annoying that i have to have my keys on me to open the trunk.
(equating the remote with key as they stay together)....
well, my stupid intermittent no power is back. grrr...
thought it might have been intermittent exhaust blockage, but it ain't
(well, at least,...
per subject line.
how do y'all do it?
And if cutting, how to cut and what to replace it with?
ideally, do not have to move brake master...
driver side front brake is a crack/hole in the exterior wall.
i still have brakes as of today.
i was doing a fluid flush and saw the crack - almost...
is there a difference between these two parts:
pics say more than words ... and this was during assembly
(the hard part).
now... who happens to know part number?
i guess, i should...
i was looking at the few tubes and where is a good source for ported vacuum?
the evap line under the throttle body? or....?
was hoping for...
Separate names with a comma.