Please see attached image.
I have replaced the shifter bushings. Recently, sometimes, when I put the car into 1st gear, it goes into 3rd gear. I then have to pull it hard...
I put it back together and I can say, wow that made a huge difference. Next time, I'm gonna use an impact wrench to loosen the head bolts a little,...
Gonna weld a nut on. Seems like block sealer in the coolant passages.
I pulled the head and broke two head bolts in the process. Seems like I have plenty of real estate to work with. I have a map torch, freeze off, wax...
What do your motor/trans mounts look like? In particular, the rear one(between trans and cabin).
Passenger side needed a little help with a tow chain
3in exhaust clamp
Slide hammer with hook
Install exhaust clamp around base of drive axle as shown.
Attach slide hammer hook in one...
Pulling a G5M from the junkyard soon. What's recommended to replace before installing? Got clutch, trans fluid. What else? Seals?
I used Raybestos on the front and rear. Threads up, no torque specs, just tighten them till you run out of threads and then stop.
Separate names with a comma.