Actually you don't even need the crossmember as the spindles will bolt directly to the crossmember, at least on the 3rd gen. The trailing arms also...
I just located an '03 G5M today and will be doing some clean up over the week. I probably won't install it right away as the current G5M works fine...
I was pulling some parts for a client when I spotted an '03 ZX2 at the back of the yard that wasn't listed on their official inventory.....and it had...
Sorry to hear it.:(
What happened to him?
Isn't there a guy that used to hang out at TeamZX2 that used to port them? John something or other.
I lowered my wagon with a set of Ground Control Coilovers. I'm running a 7.5" x 17" wheel with +40mm backspace. 205/45/17 tire. Rolled the fenders....
No rubbing issues? Is the car lowered at all?
It would probably be cheaper and faster to just swap in a Zetec.
I have a set of charcoal ZX2 floor mats in my wagon. If I get a chance I'll snap a pic and post.
Here ya go!
Where are you? I did the ATX/MTX swap but I also did the zetec swap at the same time so it wasn't as hard.
As joeytwowagons said, it'll be much...
Good to know. Thanks!
Agreed although I get that you have specific parts you're looking for but it is unnecessary to post it 3 times. Once is enough.
Your right. Weird. The second one was a new set. Must've fat fingered it when I hit "copy"
Try this one:...
Separate names with a comma.